---------------------------------------------------------- Zenith701801-List Digest Archive --- Total Messages Posted Sat 04/30/11: 2 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 07:38 PM - Machining rivet gun heads (Perry Delano) 2. 07:52 PM - Re: Re: Tail feather open spaces (Gordon) ________________________________ Message 1 _____________________________________ Time: 07:38:03 PM PST US From: "Perry Delano" Subject: Zenith701801-List: Machining rivet gun heads I'm anxious to rivet my rudder skeleton together, is there a good way to do this at home without any exotic bits or tools. If not, I'll send them to Zenith. Also, is Zinc-Chromate still the rust inhibitor of choice. Finally, I do not want to wear Joyce out at Zenith, so I'll ask the question here. I was originally going to build from plans but due to time contraints realize a kit is the only way to go. Where on the Zenith site or Builders site do I find where to buy the updated construction manual CD. Joyce tells me its there but I have not been able to find it. With the changes that have been made to the kit since I bought my plans I've found that although I avoided any mistakes in putting the rudder skeleton together there was the potential to do something wrong given the predrilling in the new kit parts. ________________________________ Message 2 _____________________________________ Time: 07:52:54 PM PST US From: "Gordon" Subject: Re: Zenith701801-List: Re: Tail feather open spaces I had a similar experience attempting full power stalls -- I think torque exceeds the control surface force. I have never been able to get the plane to do anything but a benign mush with low power. Gordon ----- Original Message ----- From: "dashwood" Sent: Saturday, April 30, 2011 2:11 AM Subject: Zenith701801-List: Re: Tail feather open spaces > > > be careful when pushing the stall . I was testing the stall at altitude > the other day. was cycling a little throttle and trying to get as steep an > angle of attack as i could. one last throttle burst and one last pull on > the stick turned it a hammerhead stall and she flipped over backwards. not > something i would recommend. reminded me i must clean the carpets more > often. > > -------- > Ross Aalexander: CH701 driver 912ul 490tt > > > Read this topic online here: > > http://forums.matronics.com/viewtopic.php?p=338505#338505 > > > ------------------------------------------------------------------------------------- Other Matronics Email List Services ------------------------------------------------------------------------------------- Post A New Message zenith701801-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/Zenith701801-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/zenith701801-list Browse Digests http://www.matronics.com/digest/zenith701801-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution ------------------------------------------------------------------------------------- These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.