Today's Message Index:
----------------------
1. 10:47 PM - Stabilizer front attachment brackets (Perry Delano)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Stabilizer front attachment brackets |
Hi all,
For all my measuring, I placed one of bracket 7H2-6 too close to the
centerline of the front spar on the stabilizer. I did not cut the skin for
it so the problem is isolated to whether I need to replace the spar or just
reposition the bracket further out drill and cleco it in a new position. It
looks like I put it at about 106 mm rather than the 126mm from the
centerline. I sent an email to zenith for their advice and will likely
follow up tomorrow. Anyone make a similar mistake? I discovered this
because I misinterpreted the drawing and cut the wrong chamfers on the
brackets and had to make new ones when I was about to position them again
and back drill the holes I found one was in the wrong place.
Building from component kits (but you guessed it, making some parts)
Perry Delano
SN 5313
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|