Today's Message Index:
----------------------
1. 07:14 AM - Re: Deburring ribs, spar, channels and wing skins RW (Perry Delano)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Deburring ribs, spar, channels and wing skins RW |
Hi all,
Thanks for the advice on deburring. I took the 12=9D vixen file I
had from Lee Valley and cut 4=9D of it. I found this was a bit
long to get between crimps, so off the 8=9D left I cut another
2=9D chunk to get between crimps. The 2=9D is handy as it
does not hit too many holes at once allowing one to do a couple holes at
a time. The longer ones work better on the spar and longer runs where
one can have a good grip on the file. Now I have a 2=9D,
4=9D and 6=9D vixen file. I used the combination to deburr
the lower right wing skeleton. It works well, but as one of the
poster=99s said, I need to round off the edges so it does not
create scratches on the skins. I will do that before deburring the lower
skin and nose skin.
Thanks again,
Regards,
Perry
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|