Today's Message Index:
----------------------
1. 06:49 AM - Re: Cutting Slots (Carlos Sa)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Cutting Slots |
Nicely done, Perry
I too use this technique on aluminum, but when I read "slots" on the
heading of your note, I thought about the slots on the firewall, for the
steering rods.
(I have been working on that area, so it's natural.)
To make those slots, I used this tool, available from the usual sources:
http://www.adelnibbler.com/
It's fairly cheap at around $30, and works nicely - of course, it also
works on aluminum.
Cheers
Carlos
On 30 August 2013 21:42, Perry Delano <pdelano@telus.net> wrote:
> Hi all,
>
>
> Most have probably figured out how to make nice slots without drilling
> countless holes in nearly a straight line. I used an Olfa Knife with a
> straight edge and a little help from my friends needle nose vice grips and
> snips. see attached photos.
>
> Now for my question: If one adds auxillary fuel tanks are they identical to
> the ones that come in the 701 wing kit or are they a different size.
>
> Regards,
>
> Perry
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|