Today's Message Index:
----------------------
1. 09:45 PM - Re: Twist Avoidance (Perry Delano)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Hi Ron, Doug, John, Carlos,
Thanks for the advice on using a level table for wing construction. I
took it to heart and basically made my work bench into a pool table,
e.g. it now has jack screws at each lag and at every hold down point on
the top (9 points on each side) there is a jack screw to adjust the bed
as needed to get it as flat and level as I can. I bought some clear hose
to make a water level and will do a final level check when I have all
the jack screws installed. I may rent one of those self leveling laser
levels to double check my work, or an optical level if I can find one.
Sorry for taking so long for a reply. Thanks again.
Regards,
Perry
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|