Today's Message Index:
----------------------
1. 04:43 PM - 7-V-7-4 Inboard Trailing Edge (Perry Delano)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | 7-V-7-4 Inboard Trailing Edge |
Hi All,
I am puzzled. As far as I can determine for the right wing (which is hung on
the wall) I cut out the inboard trailing edge as shown on the 10/2002
drawings, specifically made the the fore to aft cut 22 mm deep to allow for
clearance of 7V4-4 as shown on the lower left corner of 7-V-7. However on
the left wing the trailing edge at 7V4-4 does not seem to want to come
flush with the trailing edge of the top rear skin. It seems I would need to
make this cut about 27 mm deep. Was there an update to the drawings for this
dimension that I just don't seem to be able to find now. I am trying not to
jump to a solution that is not required.
Thank you in advance for any help with this query.
Regards,
Perry
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|