Today's Message Index:
----------------------
1. 04:47 PM - Re: 7-V-7-4 Inboard Trailing Edge (JohnDRead@aol.com)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: 7-V-7-4 Inboard Trailing Edge |
Call the factory.
John Read
Home: 303.648.3261
Mobile: 719.494.4567
In a message dated 10/27/2014 5:43:48 P.M. Mountain Daylight Time,
pdelano@telus.net writes:
Hi All,
I am puzzled. As far as I can determine for the right wing (which is hung
on the wall) I cut out the inboard trailing edge as shown on the 10/2002
drawings, specifically made the the fore to aft cut 22 mm deep to allow
for
clearance of 7V4-4 as shown on the lower left corner of 7-V-7. However on
the left wing the trailing edge at 7V4-4 does not seem to want to come
flush
with the trailing edge of the top rear skin. It seems I would need to mak
e
this cut about 27 mm deep. Was there an update to the drawings for this
dimension that I just don=99t seem to be able to find now. I am try
ing not to
jump to a solution that is not required.
Thank you in advance for any help with this query.
Regards,
Perry
========================
============
========================
============
========================
============
========================
============
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|