Today's Message Index:
----------------------
1. 07:08 AM - Re: 7-V-7-4 Inboard Trailing Edge (Perry Delano)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | 7-V-7-4 Inboard Trailing Edge |
Hi John,
As always; good advice.
Regards,
Perry
From: owner-zenith701801-list-server@matronics.com
[mailto:owner-zenith701801-list-server@matronics.com] On Behalf Of
JohnDRead@aol.com
Sent: Tuesday, October 28, 2014 4:47 PM
Subject: Re: Zenith701801-List: 7-V-7-4 Inboard Trailing Edge
Call the factory.
John Read
Home: 303.648.3261
Mobile: 719.494.4567
In a message dated 10/27/2014 5:43:48 P.M. Mountain Daylight Time,
pdelano@telus.net writes:
Hi All,
I am puzzled. As far as I can determine for the right wing (which is
hung on the wall) I cut out the inboard trailing edge as shown on the
10/2002 drawings, specifically made the the fore to aft cut 22 mm deep
to allow for clearance of 7V4-4 as shown on the lower left corner of
7-V-7. However on the left wing the trailing edge at 7V4-4 does not
seem to want to come flush with the trailing edge of the top rear skin.
It seems I would need to make this cut about 27 mm deep. Was there an
update to the drawings for this dimension that I just don=99t seem
to be able to find now. I am trying not to jump to a solution that is
not required.
Thank you in advance for any help with this query.
Regards,
Perry
List
href="http://www.matronics.com/Navigator?Zenith701801-List">http://www.
matronics.com/Navigator?Zenith701801-List
ms.matronics.com/">http://forums.matronics.com
tp://www.matronics.com/contribution">http://www.matronics.com/contributio
n
No virus found in this message.
Checked by AVG - www.avg.com
10/28/14
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|