Today's Message Index:
----------------------
1. 06:20 AM - Re: Angle Drill Requirement (Carl)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Angle Drill Requirement |
Hi Perry.
I do not recall using an angle drill at any time during the build 20 years
ago but I have purchased one since and used it on a few occasions. I have
both the drill and an angle adaptor for an ordinary drill purchased at
Princess Auto in Ottawa at a very reasonable price. Hope this helps.
Carl
----- Original Message -----
From: "Perry Delano" <pdelano@telus.net>
Sent: Sunday, March 06, 2016 3:01 PM
Subject: Zenith701801-List: Angle Drill Requirement
>
> Hi all,
>
> For 7F10-2 Channel Doubler on the forward fuselage, the manual says an
> angle drill is required. It is not obvious why, but I went looking for one
> and have not found anything priced commensurate
> with the job. Is an angle drill really necessary for this part and
> possibly others. If so, does anybody have suggestions of where to find one
> in Canada.
>
> Regards,
>
> Perry
>
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|