Today's Message Index:
----------------------
0. 12:21 AM - Please Make A Contribution To Support Your Lists (Matt Dralle)
1. 02:30 PM - Re: Zenith750-List Digest: 3 Msgs - 11/11/08 (silverbirch1@netzero.net)
Message 0
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Please Make A Contribution To Support Your Lists |
Dear Listers,
There is no advertising income to support the Matronics Email Lists and Forums.
The operation is supported 100% by your personal Contributions during the November
Fund Raiser.
Please make your Contribution today to support the continued operation and upgrade
of these services. You can pick up a really nice gift for making your Contribution
too!
You may use a Credit Card or Paypal at the Matronics Contribution Site here:
http://www.matronics.com/contribution
or, you can send a personal check to the following address:
Matronics / Matt Dralle
PO Box 347
Livermore, CA 94551-0347
Thank you in advance for your generous support!
Matt Dralle
Matronics Email List and Forum Administrator
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Zenith750-List Digest: 3 Msgs - 11/11/08 |
Stefan, -- I am building a CH750 from a kit. I have built on the horizo
ntal stabilizer. In fitting the skin I found that the cutouts for the f
ront brackets were about 10mm too far apart. They need to be trimmed in
board about 4mm each to fit over the front brackets.
I have also built up the elevator and trim tab. The manual discusses wh
ere to drill and mount the horn angle (75T3-6) in the elevator skeleton
section (75-TA3), page 6. The exact location of the horn angle on the s
par is critical since it must be flush with the upper horn (75T3-7) and
lower horn (75TA-8). The upper and lower horns are predrilled. If the
horn angle is already drilled to A5, as instructed, there is little room
for adjustment when attaching the elevator horns. The horns should lik
ely be clecoed to the skeleton and the horn angle positioned before the
horn angle is drilled, at least to A5 size.
Thank you for your web site Stefan.
_____________________________________________________________
Compete with the big boys. Click here to find products to benefit your
business.
http://thirdpartyoffers.netzero.net/TGL2221/fc/Ioyw6i4t3HXJcvgIbKSZUqXpT
RVjHPcBmXw6xXPbvjV17Kbc39vQHU/?count=1234567890
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|