Today's Message Index:
----------------------
1. 01:19 PM - Zenith 750 on the cover of KitPlanes (Craig Payne)
2. 02:00 PM - Re: Wings (ken carp)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Zenith 750 on the cover of KitPlanes |
www.kitplanes.com
But you have to be a subscriber to read the article.
-- Craig
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
have finished the right wing. Factory says the two rivets at the spar tip need
to be removed and redone with A5s when the tip is put on. I also found three
rivets missing from one of the vertical doublers...put is A5s myself. all went
without problem but need care with the rear strut fitting, rivet it from inside
after the trailing edge is half on. They tell me the top root panel is
usually put on when the wing is fitted to the plane. You are not to rivet the
rib on the bottom behind the front strut fitting. an L piece goes in there later.
I think the back two or three rivets are ok to install. It is like the
701 there. Look at the posted detail pictures of the 750.
ken carpenter kit # 75-7423(what ever that means)
--------
ken carpenter
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=220446#220446
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|