Today's Message Index:
----------------------
 
     1. 03:52 AM - Re: Rudder (Robert Pelland)
     2. 12:17 PM - Re: Rudder (Joe Harrington)
 
 
 
Message 1
| 					INDEX |  Back to Main INDEX |  
| 					NEXT |  Skip to NEXT Message |  
| 	LIST |  Reply to LIST Regarding this Message |  
| 		SENDER |  Reply to SENDER Regarding this Message |  
  | 
      
      
      
      Joe, 
      
      I am in exact same position as you are, and was told by the factory that 
      they are identical.  However as almost all the .016 mil aluminum that is 
      seen in the 701, is being replaced with .020 thou in the 750, I made 
      both my rudders in .020 thou.
      
      Shirley from Zenith confirmed that my plans for the 750 were sent out 
      Airmail last Tuesday, and I am expecting then in today, so I will 
      confirm the build details, size, and thickness of the materials used as 
      soon as they come in.
      
      Robert the 701 & 750 Scratch
      
        ----- Original Message ----- 
        From: Joe Harrington 
        To: Zenith 750 List 
        Sent: Sunday, February 15, 2009 8:08 PM
        Subject: Zenith750-List: Rudder
      
      
      
        While I am waiting for my plans, I was thinking I might start on the  
        rudder. I have a friend with 701 plans and was wondering if the  
        rudder was the same. I read somewhere ( I think here) that they are  
        the same. Are they EXACTLY the same? IE same material thickness, same  
      
        rivet spacing, etc? If so might start on the blocks this week.
      
        Thanks in advance,
        Joe
      
      
Message 2
| 					INDEX |  Back to Main INDEX |  
| 				PREVIOUS |  Skip to PREVIOUS Message |  
| 					NEXT |  Skip to NEXT Message |  
| 	LIST |  Reply to LIST Regarding this Message |  
| 		SENDER |  Reply to SENDER Regarding this Message |  
  | 
      
      
      
      
 
Other Matronics Email List Services
 
 
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
 
 
-- Please support this service by making your Contribution today! --
  
 |