Today's Message Index:
----------------------
1. 10:45 PM - Standard L angle dimensions (Joe Harrington)
2. 10:58 PM - Re: Standard L angle dimensions (Craig Payne)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Standard L angle dimensions |
Hi,
The assembly manual refers to using some standard L angle aluminum. I
have looked through the plans, assembly manual, construction
standards but can't see what the dimensions are. Is it 20mm flanges x
0.025"? Or what? Thanks in advance.
Joe
750 Scratch Build
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Standard L angle dimensions |
I only have the 701 and 601XL plans but look on some of the first pages of
the plans. The width before bending (Developed Length) is 36 mm and is bent
from 0.025 inch sheet. Bend with a radius of 1/8th inch. They are generally
made across the full width of a 4 foot sheet so are called out with a length
of 1219 mm. I wrote an article on a simple press brake made out of 2 by 4s
and C-clamps for bending these if you want it. It was in the Zenith
newsletter a few issues ago.
-- Craig
-----Original Message-----
From: owner-zenith750-list-server@matronics.com
[mailto:owner-zenith750-list-server@matronics.com] On Behalf Of Joe
Harrington
Sent: Friday, May 08, 2009 11:44 PM
Subject: Zenith750-List: Standard L angle dimensions
Hi,
The assembly manual refers to using some standard L angle aluminum. I
have looked through the plans, assembly manual, construction
standards but can't see what the dimensions are. Is it 20mm flanges x
0.025"? Or what? Thanks in advance.
Joe
750 Scratch Build
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|