Zenith750-List Digest Archive
Mon 02/21/11 |
Total Messages Posted: 1 |
Today's Message Index:
----------------------
1. 03:09 PM - Elevator width (Gordon Arbeitman)
Message 1
INDEX Back to Main INDEX NEXT Skip to NEXT Message LIST Reply to LIST Regarding this Message SENDER Reply to SENDER Regarding this Message
Time: 03:09:45 PM PST US
From: Gordon Arbeitman <gordona23@earthlink.net>
Subject: Elevator width
When I did a trial attach of the elevator and horizontal stabilizer, I
found that the elevator was slightly shorter than the HS (about 10 MM).
And the difference is
mostly on the left side of the center attach point. In other words,
with the center pivot clecoed, the right side pretty much lines up and
the left side shows a 10MM
offset. Here are my questions:
1. Do I care ?
2. Are washers allowed in the center pivot to shift the elevator ?
As usual, thanks for any advice.
Other Matronics Email List Services
Post A New Message zenith750-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/Zenith750-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com 7-Day List Browse http://www.matronics.com/browse/zenith750-list Browse Zenith750-List Digests http://www.matronics.com/digest/zenith750-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.