Matronics Email Lists

where is the best place to buy rebuild kits?

Warren Miller
Kitfox IV
582 rotax
N369pl

I just recently put the oil injection back on my engine. This added another spring for the throttle wire to push against.

Warren Miller

The cable clamp is supposed to pivot in the mixer. My clamp was binding causing the wire to bend back and forth. The wire broke right at the cable clamp. Throttle control was a A-790 (acs 05-08036). I ...

Just had my 582 rebuilt. Was in the process of doing the Rotax breakin procedure. Pushed throttle in for the first high rpm blast. Engine rpm dropped out. Thought it was a major problem. Turned out ca ...

I had the same problem. the spring for the lock had become weak. I stretched the spring then reinstalled it. The next time I ordered parts I ordered a new one. When I park my plane I make sure to lock ...

I am running 3to1 with a 3 blade GSC prop. At 6000 rpm I indicate 110mph but I think the actual airspeed is 90mph.

Noel.
The temp drops as soon as you tune the switch off. It raises as soon as you turn it on.It does the same with the position lights and the cabin heater. The rpms stay constant.
Warren

I flew my plane yesterday for a about 30 min. I used batteries in the gps instead of the 12v plane power. I had no noise. I then unhooked the batteries and plugged back into the plane and still no noi ...

I was flying my plane last weekend. I noticed I had a lot of radio noise. was flying with two other planes. They said radio transmission was garbled. I started experimenting turning off electronic thi ...

The part #on my caps is TBO5EMA NGK I checked on of them it read 6.2 Ohms. Is this the proper part #?

I posted the same question a few months ago. Some one sugested the keywest reggulator. It provides a more constant voltage on my aircraft. I also think it reduced my radio noise. But mine is on the in ...

I posted the question on what regulator to use on the kitfox site. They suggested a keywest regulator. I installed on and it has performed flalessly. I even have less radio noise

I also had the same problem on a 503 I used to fly on a n3pup. The pule line was to long. Their is a specification of no longer than 12". If memory serves me well.

Don I never had the original bottle. Which size did you use? Did you have to remove the cowling to refill the bottle? My cowling has a small door close to the back of the cylinder head of the engine.

I have a kitfox IV with a 582. The original builder removed the oil injection and premixed his fuel. I want to reinstall the oil injection. Which oil tank will fit under the cowl 582 side mount #881 4 ...

Don

I have a kitfox model IV. I live in Taylorsville North Carolina.
Warren Miller

I have a kitfox with a 582. The builder of the airplane decided to remove the injection pump and premix 80:1 with NEO synthetic oil. The engine runs fine but I would like to go back to oil injection. ...

I have a model 4 with a 582 rotax. My volt guage reads 12 to 16volts. In flight. the last time I flew it after about 10 min it droped to 12volts and stayed their. I currently have the regulator/recti ...

Is there a minimum space? Maybe it could be checked with feeler blades. Does anyone know what the spec is? or is enough to say there is a space?

Warren Miller
IV-1050
582 Rotax