Re: built up spars

Next Msg:		ivan.todorovic		Re: rib/spar orientation
Previous Msg:		Pieti Lowell		Re: rib/spar orientation
Maybe in Reply-To:		Oscar Zuniga		built up spars
Next in Thread:		ivan.todorovic		Re: built up spars

Subject:		Re: built up spars
From:		ivan.todorovic (tosha@sezampro.rs)
Date:		Thu Nov 19 - 7:28 AM

Peter,

Please check if I've messed the dimensions for the front spar on the drawings below.

Maybe it is a stupid question, but better safe than sorry: spar face with full
plywood web goes in the wing-tip direction for both spars, front and rear, right?
There is a small drawing near the right edge of your sketch that made me uncertain
about that.

One other thing: vertical stiffeners position on the spar inside edge would need
a hint or two, there are several dimensions (7 1/2), (1/2 + 8 1/2) that are
a bit confusing.

Regards,
Ivan


Read this topic online here:

http://forums.matronics.com/viewtopic.php?p=273710#273710


Attachments: 

http://forums.matronics.com//files/frontsparinside_144.jpg
http://forums.matronics.com//files/frontspartip_262.jpg