Hi,
Good Luck finding this set up as Mark isn't making this stuff for the time
being. I have this same set up (MKII) on my flying F1 Rocket. My current F1
Rocket project has the MKI set up and I'm converting it to the MKII.....only
because I want the flap bar at the aft end of the rear seat cushion. I
purchased the 6" throw flap motor from Team Rocket and the RV8 flap torque
tube from Vans (the RV8 runs a 5" throw motor). The RV8 torque tube is close
but no cigar and will have to be cut in half and shortened by about 1.5". In
addition the motor attach will have to be relocated. Then, I'll have to make
my own 'doghouse' to cover the torque tube under the seat cushion. Probably
NOT worth the effort and the money but I already have the parts so I figure
I'll use them. Plus it messes up the left side arm rest arrangement for the
passenger.
If you want the MKI parts let me know. I have all the hardware, motor that
attaches to the floor, and the torque tube.
Good Luck,
Rick Gray in Ohio at the Buffalo Farm
----- Original Message -----
From: "Rainair" <RaReubelt@aol.com>
To: <rocket-list@matronics.com>
Sent: Friday, November 28, 2008 2:50 PM
Subject: Mk2. Flap System
>
> Hello,
>
> I'm searching this flap system :
>
> http://www.pflanzer-aviation.com/fuselage78.jpg
>
> can everybody help me ?
>
>
> Read this topic online here:
>
> http://forums.matronics.com/viewtopic.php?p=216725#216725
>
>
>
