Check the surface of the oil transfer tube as well as the inner surface of
the dome, both should be very smooth without any defects. If after you
replace the seals you still have the problem you are most likley missing the
alu seal ring which is (should be) under the oil transfer tube. This seal
ring, and the dome seals are the same in both the V530 and the CJ prop.
Hope this helps.
Always Yakin,
doug
On Thu, Oct 9, 2008 at 12:48 PM, Peter K. Van Staagen
<petervs@knology.net>wrote:
> My Yak52 is leaking engine oil from the prop hub. I have the two new
> seals. Anything to watch out for when replacing the seals? Any guidance?
>
>
> Pete
>
> __|__
>
> __|__ ----=(***)=----
>
> __|__ ----=(***)=----
> __|__ ----=(***)=----
> ----=(***)=----
>
>
> *
>
> *
>
>
--
Always Yakin,
Doug Sapp
Phone 509-826-4610
Fax 509-826-3644
