So how do you vent your tanks? The caps on the 601XL are not vented but they
are on the 701. Did you add a vent when you built your tank?
-- Craig
-----Original Message-----
From: owner-zenith701801-list-server@matronics.com
[mailto:owner-zenith701801-list-server@matronics.com] On Behalf Of Brady
Sent: Saturday, November 29, 2008 11:18 AM
To: zenith701801-list@matronics.com
Subject: Re: Flush fuel caps
<brady@magnificentmachine.com>
Vic,
The Caps are the same ones the 601 boys use. I got them from Aircraft spruce
# 05-28666.
To get the flange to sit flush with the skins I had to adjust the angle of
the threaded bung that is welded into the tank. Because I welded my own
tanks and I knew I wanted flush caps from the out set, I just welded them in
at the correct angle.
I don't think this would be an easy retro fit. :)
To keep the skin tight to the flange I put a piece of soft foam (like a
sponge) between the skin & the tank to evenly hold it up and then just
screwed the cap flange down over it.
Clear as mud? :)
--------
Brady McCormick
Poulsbo, WA
www.magnificentmachine.com
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=216883#216883
