Today's Message Index:
----------------------
1. 04:28 PM - Dynon Autopilot installation (Alex Kozloff)
2. 05:37 PM - Rick Thomasson's exhaust system maintenance (John Schussler)
3. 06:01 PM - Re: Dynon Autopilot installation (rockford67)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Dynon Autopilot installation |
Hey Gang:
Has anyone installed a Dynon autopilot in their craft?
If so, did you use the SV32 servos with the standard arm and the Generic
Servo mounting kit?
Did you go to the extra expense of adding the AP74 interface and wiring
harness?
Want to have this unit installed for the September Pulsar gathering in
Lawrence, KS
Anxious in Santa Paula,
--
Alex Kozloff
P.O. Box 866
Santa Paula, CA 93061
(949) 400-6364 Cell
(805) 525-1415 Office
_!_
O-O-(_)-O-O
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Rick Thomasson's exhaust system maintenance |
I am doing some deferred maintenace on my Pulsar after 500 flying hours
in 11years. All the rubber replacement parts list. Any advice on that
work?
I pulled the exhaust to repair them while plane is down. Some general
rust where Jet Hot coating flaked off and where new thicker tabs were
welded on years ago.
Two pinholes near welds are repaired with Cargo ThermoSteel, holding for
now but will eventually come loose. I'd like to have muffler bead
blasted, pinholes
repaired and repainted. There are no cracks, just holes. What do you
recommend? Weld over pinholes? Reweld joints and try to keep same
alignment? What has been
learned from field experience with this exhaust system? I don't follow
the listvery well so may have missed new info during the past 6 years.
I sent Rick an email asking for a update on his exhausting experience,
but that addressed bounced. Rick- you out there? Probably in Lawrence...
What has worked best to seal the exhaust joints- fiber/vermiculite
strips from McMaster-Carr? I used stainless tape last time, held OK.
Should I paint them with high temp alum finish or send them to Jet Hot
to replace the original coating? Should I buy new mufflers? the pipes
are all fine.
John Schussler
Pulsar XP
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Dynon Autopilot installation |
Hey Alex,
I plan on the same installation and I haven't figured out which one yet either.
Are you planning on altitude hold as well? Are you retrofitting a Dynon by any
chance? I've got my eye on the Skyview.
I look forward to seeing how you make out.
Regards,
Chris
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=351056#351056
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|