Today's Message Index:
----------------------
1. 09:23 AM - Trim servo (Scott MacIntyre)
2. 10:17 AM - Re: Trim servo (Myron Truex)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
Hi
I have a Pulsar XP and am updating the trim servo (pitch). The old
unit was horrible and I want to use a Ray Allen T3-12 unit which will
give 1.2" of travel on my bias spring. The old system allowed 60mm or
2.3" so I would have to double the distance travelled by a lever or
pulley and so double the effort required. Any idea what the best way
to utilise one of these servos for pitch might be ?
Regards
Scott MacIntyre
23 Mellor Road
New Mills
Derbyshire
SK22 4DP
UK
UK Mobile: +44 7860 208432
US Mobile: +1 (818) 397-0666
Email: scott@s-f-x.com
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
Scott, check these servos out. Much more powerful than the Mac ones I
installed. No need to add levers etc. They draw little current and would
have no problem with travel.
Linear actuator for the trim kit is 6104T 4" full travel, .5 inches per
second. Paid $114
110 lb load 8.5 inches to 12.5 inches
Accele
562-809-5090
P.O. Box 92139
Long Beach Ca. 90809
------------------------------------------------------
The actuator has a total travel of 4 inches. That is two inches each way of
center. It is about 12 inches long. I marked the center, and each end of
travel with a circle as seen in
_____
From: owner-pulsar-list-server@matronics.com
[mailto:owner-pulsar-list-server@matronics.com] On Behalf Of Scott MacIntyre
Sent: Tuesday, May 07, 2013 9:20 AM
Subject: Pulsar-List: Trim servo
Hi
I have a Pulsar XP and am updating the trim servo (pitch). The old unit was
horrible and I want to use a Ray Allen T3-12 unit which will give 1.2" of
travel on my bias spring. The old system allowed 60mm or 2.3" so I would
have to double the distance travelled by a lever or pulley and so double the
effort required. Any idea what the best way to utilise one of these servos
for pitch might be ?
Regards
Scott MacIntyre
23 Mellor Road
New Mills
Derbyshire
SK22 4DP
UK
UK Mobile: +44 7860 208432
US Mobile: +1 (818) 397-0666
Email: scott@s-f-x.com
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|