Today's Message Index:
----------------------
0. 12:09 AM - Value of the List... (Matt Dralle)
1. 01:52 PM - Re: Radio Engine Noise (Bernard Wilder)
2. 02:25 PM - Re: Pulsar-List Digest: 3 Msgs - 11/18/14 (Mark Fox)
Message 0
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Value of the List... |
If you look forward to checking your List email everyday (and a lot of you have
written to say that you do!), then you're probably getting at least $20 or $30
worth of Entertainment from the Lists each year. You'd pay twice that for a
subscription to some magazine or even a dinner out. Isn't the List worth at least
that much to you? Wouldn't it be great if you could pay that amount and get
a well-managed media source free of advertising, SPAM, and viruses? Come to
think of it, you do... :-)
Won't you please take a minute to make your Contribution today and support these
Lists?
http://www.matronics.com/contribution
Or, drop a personal check in the mail to:
Matt Dralle / Matronics
581 Jeannie Way
Livermore CA 94550
USA
I want to say THANK YOU to everyone that has made a Contribution thus far during
this year's List Fund Raiser!! These Lists are made possible exclusively through
YOUR generosity!!
Thank you for your support!
Matt Dralle
Email List Admin.
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Radio Engine Noise |
Had same problem.
Went to Radio Shack bought a couple noise suppression coils. Ran leads from
voltage regulator through them. Killed the noise.
Learned that from the electrical engineer at the last Pulsar gathering. If
he is listening maybe he can be more specific.
Berne Wilder
On Tue, Nov 18, 2014 at 5:07 PM, Mark Fox <saafbusiness@gmail.com> wrote:
> I have had my Pulsar for a long time...18 years....always has some engine
> noise on transmission
>
> But is seems to be much worse on transmission....engine noise
>
> I am using a handheld Icom radios attached to the dash and always had good
> luck
>
> I think I have an Icon IC-A23 now
>
> Anyone had good luck with noise filters ?
>
> Thanks
>
> --
>
> [image: Mark L. Fox Vice President 321-626-4786]
> <http://myesig.com/esig/link-174057.php>
> <http://myesig.com/esig/link-174063.php>
> <http://myesig.com/esig/link-174061.php>
> <http://myesig.com/esig/link-174062.php>
>
> myesig.com <http://www.myesig.com/r.php?rc=CEA8A3>
>
> *
>
>
> *
>
>
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Pulsar-List Digest: 3 Msgs - 11/18/14 |
Thanks Myron
I do have an intercom and yes I am using aircraft power to power the
handheld radio
Are you saying to use the battery inside the radio or run the power
directly to the aircraft battery ?
If will try both but using the internal radio battery requires charging it
constantly of course which is a pain
I will try your other suggestions....as I figured, it is a trail and error
of chasing like most electrical issues:)
Thanks
On Wed, Nov 19, 2014 at 2:59 AM, Pulsar-List Digest Server <
pulsar-list@matronics.com> wrote:
> *
>
> =================================================
> Online Versions of Today's List Digest Archive
> =================================================
>
> Today's complete Pulsar-List Digest can also be found in either of the
> two Web Links listed below. The .html file includes the Digest formatted
> in HTML for viewing with a web browser and features Hyperlinked Indexes
> and Message Navigation. The .txt file includes the plain ASCII version
> of the Pulsar-List Digest and can be viewed with a generic text editor
> such as Notepad or with a web browser.
>
> HTML Version:
>
>
> http://www.matronics.com/digest/digestview.php?Style=82701&View=html&Chapter 14-11-18&Archive=Pulsar
>
> Text Version:
>
>
> http://www.matronics.com/digest/digestview.php?Style=82701&View=txt&Chapter 14-11-18&Archive=Pulsar
>
>
> ===============================================
> EMail Version of Today's List Digest Archive
> ===============================================
>
>
> ----------------------------------------------------------
> Pulsar-List Digest Archive
> ---
> Total Messages Posted Tue 11/18/14: 3
> ----------------------------------------------------------
>
>
> Today's Message Index:
> ----------------------
>
> 1. 01:03 AM - Re: Earth X lithium battery in 582 pulsar (Herbert
> Schmaderer)
> 2. 02:08 PM - Radio Engine Noise (Mark Fox)
> 3. 02:53 PM - Re: Radio Engine Noise (myrontruex)
>
>
> ________________________________ Message 1
> _____________________________________
>
>
> Time: 01:03:53 AM PST US
> From: Herbert Schmaderer <herbert.schmaderer@aon.at>
> Subject: Re: Pulsar-List: Earth X lithium battery in 582 pulsar
>
> I am useing the Ballistic Performance Components model EV02 on my 912S
> since 18 month. Charging voltage is determined by the regulator device
> 13,6V. Very good start characteristic in winter time, once you get used
> to the specifics of a Lithium battery.
>
> Herbert
> OE-CHS
>
> Am 17.11.2014 20:27, schrieb Everett Collier:
> > Is anyone else using a lithium battery in their Pulsar?
> > I put an Earth X lithium battery in my 582 powered Pulsar. Much
> > lighter than the old battery. I only have one flight on it, and am
> > doing my annual now, so will be a few days before i fly again. What I
> > am wondering about is that during the flight, I checked the battery
> > voltage and it was only showing 12.8 to 12.9 volts. I think i was
> > seeing 13.3 before. not sure what is going on and was wondering if
> > anyone else is using one.
> >
> > Everett Collier
> > N167EC
> > *
> >
> >
> > *
>
>
> ________________________________ Message 2
> _____________________________________
>
>
> Time: 02:08:11 PM PST US
> Subject: Pulsar-List: Radio Engine Noise
> From: Mark Fox <saafbusiness@gmail.com>
>
> I have had my Pulsar for a long time...18 years....always has some engine
> noise on transmission
>
> But is seems to be much worse on transmission....engine noise
>
> I am using a handheld Icom radios attached to the dash and always had good
> luck
>
> I think I have an Icon IC-A23 now
>
> Anyone had good luck with noise filters ?
>
> Thanks
>
> --
>
> [image: Mark L. Fox Vice President 321-626-4786]
> <http://myesig.com/esig/link-174057.php>
> <http://myesig.com/esig/link-174063.php>
> <http://myesig.com/esig/link-174061.php>
> <http://myesig.com/esig/link-174062.php>
>
> myesig.com <http://www.myesig.com/r.php?rc=CEA8A3>
>
> ________________________________ Message 3
> _____________________________________
>
>
> Time: 02:53:53 PM PST US
> From: "myrontruex" <MyronTruex@comcast.net>
> Subject: Re: Pulsar-List: Radio Engine Noise
>
> Mark, are you using power from the airplane or the battery on the radio?
> If you are connected to the aircraft power try unplugging it and running
> it straight from the battery. If you have an intercom installed and it
> is powered by the aircraft you could have the noise entering there. My
> turn and bank indicator was producing a lot of hash until I did some
> filtering inside it.
> Your best source for clean power is to run a cable to the battery where
> it can do its job. Yes a filter can help but it can be difficult to find
> just where the noise is being injected into the system. If you have an
> intercom and a pigtail on your radio you may be able to bypass the
> intercom for a test. Loose screws on the headset plug wires can allow
> electrical noise to enter the system too. Clean and tighten all the
> connections.
>
> Myron
>
>
> From: Mark Fox
> Sent: Tuesday, November 18, 2014 5:07 PM
> Subject: Pulsar-List: Radio Engine Noise
>
>
> I have had my Pulsar for a long time...18 years....always has some
> engine noise on transmission
>
>
> But is seems to be much worse on transmission....engine noise
>
>
> I am using a handheld Icom radios attached to the dash and always had
> good luck
>
>
> I think I have an Icon IC-A23 now
>
>
> Anyone had good luck with noise filters ?
>
>
> Thanks
>
>
> --
>
>
> myesig.com
>
>
--
[image: Mark L. Fox Vice President 321-626-4786]
<http://myesig.com/esig/link-174057.php>
<http://myesig.com/esig/link-174063.php>
<http://myesig.com/esig/link-174061.php>
<http://myesig.com/esig/link-174062.php>
myesig.com <http://www.myesig.com/r.php?rc=CEA8A3>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|